Solar Panel Installation in Midwood, Brooklyn
Midwood is really two neighborhoods for solar purposes, and they need two different installations. Inside Fiske Terrace and Midwood Park you have large freestanding wood-frame Victorians on their own lots, landmarked since 2008, with steep pitched roofs and slate or shingle. A few blocks away you have attached and semi-detached brick houses with flat roofs and no landmark status at all. Same neighborhood name, different building type, different mounting system, different permitting. We have completed ten permitted installations across Midwood and Mapleton.
Get a Free Midwood Solar Quote – (718) 962-7699
Midwood one: the Victorians in Fiske Terrace and Midwood Park
The Fiske Terrace-Midwood Park Historic District was designated in March 2008. It protects an unusual concentration of large freestanding houses from the early 1900s – wood-frame, generously set back, with porches, gables and steep pitched roofs.
Three things follow from that, and they all change the job:
- Landmarks review applies. A Landmarks Preservation Commission permit comes before the Department of Buildings will issue yours. LPC approves most rooftop solar at staff level when it cannot be seen from the street, and streamlined environmental-upgrade review in 2023 – but the application has to be made. We file it in-house.
- The roof is the architecture. Unlike a brownstone where a flat roof hides behind a cornice, these houses have prominent pitched roofs visible from the street on several sides. The rear slope is usually the workable one, and which slopes are visible has to be checked from the sidewalk, not from a plan.
- Wood frame changes the attachment. Mounts land on rafters and the flashing is integrated into the shingle or slate course. Slate in particular is unforgiving – it is brittle, it is expensive to match, and it is not something to hand to a crew that mostly does flat roofs.
Systems on these houses typically land in the 5 to 9 kW range, constrained by which slopes are usable rather than by total roof area.
Midwood two: the attached and semi-detached brick houses
Away from the historic district, most of Midwood and neighbouring Mapleton is attached or semi-detached brick with flat or low-slope roofs. This is where the majority of our ten local installations are.
Here there is no Landmarks review at all – straight to DOB and Con Edison – and the mounting is ballasted rather than penetrating: the array is held by weight, nothing goes through the membrane, and it lifts off cleanly if the roof is replaced. Fire-code access paths take real area out of a narrow roof, but these houses are often deeper than they are wide, which helps. Expect roughly 8 to 13 kW on a semi-detached house with a rear extension.
Many are also two-family. Net metering credits only the meter the array is interconnected to, so if your house has more than one Con Edison account we review twelve months of usage on each before deciding which the system should feed.
Which Midwood are you in?
The boundary is not obvious from the architecture on every block, and it decides whether your project needs a Landmarks application and whether the 20% state historic credit is even a possibility. We confirm your address against the district before any design work. If you are getting quotes and nobody has asked exactly where you are, they do not yet know what your job involves.
The 20% historic credit – only for the district
If your house is in Fiske Terrace-Midwood Park, the New York State Historic Homeownership Rehabilitation Credit may apply: 20% of qualifying work, capped at $25,000 per taxpayer per year, with solar qualifying when the panels are not visible from the street.
The conditions are strict: owner-occupied; a contributing building in a State or National Register district or individually listed – a different list from NYC landmark designation, and being inside a district is not enough on its own; in a qualifying census tract at or below 100% of the state family median income; and at least $5,000 of work with 5% or more on the exterior.
We check before putting it in a proposal. You can confirm your own address with the State Historic Preservation Office on 518-237-8643, or read the terms on the NYS Parks homeowner tax credit page. Outside the district this credit does not apply at all.
What applies across all of Midwood
- NYC property tax abatement – 30% of eligible system cost, at 7.5% per year over four years. Follows the building, so a leased system still earns it
- NYS solar equipment credit – 25% of installed cost, capped at $5,000, separate from the historic credit
- NYSERDA NY-Sun – per-watt incentive, already in your price
- Con Edison net metering – credit for exported power
- $0-down and prepaid lease – the financing company claims the business-side federal credit and passes it through as a lower payment
The 30% federal residential credit ended for systems placed in service after December 31, 2025, so buying outright earns nothing federally now.
Roof condition, and why the roof type matters here
Roofing is part of what we take on – we contract the roof work through our roofing partner and manage it alongside the solar, which is worth more than usual in a neighborhood with both slate Victorians and flat brick roofs. On a pitched slate roof the assessment is about the condition of the slate and the underlayment; on a flat roof it is membrane life. Either way, under ten years left and we will tell you to do the roof first, even though it delays the solar job.
Equipment is tier-one: Qcells, Enphase, Trina Solar, Maxeon, SEG Solar and Axitec, backed by a 30-year warranty through Solar Insure covering panels, inverters, racking and labor, with real-time monitoring.
Why Midwood homeowners use Solar Pro
- Ten permitted rooftop installations across Midwood and Mapleton
- Brooklyn-based – our office is in Bed-Stuy
- We do both roof types properly: ballasted flat roofs and flashed pitched slate or shingle
- Hundreds of solar installations across New York City, including landmarked and historic-district homes
- 5.0-star rated with 95 verified Google reviews
- Licensed & insured, NABCEP-certified, BBB A+ accredited
- Landmarks filing, DOB permits and Con Edison interconnection handled in-house
Book Your Free Midwood Solar Consultation – (718) 962-7699
Midwood solar questions
Is my house in the historic district?
Fiske Terrace-Midwood Park covers only part of Midwood. Send us your address and we will confirm before designing, because it determines both the permitting and whether the 20% credit is even possible.
Can I put solar on a slate roof?
Yes, with the right flashing and someone who has handled slate before. It is brittle and hard to match, so it is not a roof to learn on.
How big a system fits?
Roughly 5 to 9 kW on a Victorian where usable slopes are the constraint, and 8 to 13 kW on a semi-detached brick house with a rear extension.
Will Landmarks let me put panels on a Victorian?
Generally yes, on a slope that is not visible from the street, with a reversible installation. That normally clears staff-level review without a hearing.
Get a free Midwood solar assessment
We will confirm whether you are inside Fiske Terrace-Midwood Park, assess the roof for its actual type, review twelve months of Con Edison usage on every meter, check your property tax bill, and tell you what the roof would realistically produce and cost – including whether the historic credit is genuinely available. If the roof needs work first, we will say so.
Request your free Midwood solar assessment – or call (718) 962-7699.
The in-district-or-not question plays out the same way in Bed-Stuy, and immediately north the two- and three-family houses of Flatbush and East Flatbush raise the question of which meter your array should feed.
Serving all of Brooklyn – see our Brooklyn solar page or every Brooklyn neighborhood we cover.
Already have solar? We also service systems we did not install – repair and diagnostics, panel removal and reinstallation for roof work, and systems whose original installer has closed.